Hi,

One for all you POTF coin collectors out there -- what is the size of the Air-Tite rings that best holds these? I have quite a few ring holders in my possession that came with the coins I've been getting recently, but can't make heads or tails of the measurements and what size they *actually* are going by the air-tites.com website

I want to buy a bulk load with black foam rings in order to put together a nice frame for the full set -- so obviously want to get my order correct first time around!

I think what I have are size X6? Not sure about the ring size though. Can any one offer any advice? And also, does anyone know a good reseller here in the UK?

Cheers, Jared.

I see X6 is for thick coins. I'm pretty sure you need I 39mm foam ring.


or go for: http://www.spinettisgaming.com/Chip-Insert-63-Chips/

Yes, I think you are right -- 39mm foam rings look to be a good fit.

I have just ordered a couple of these sets to try out:

http://www.coingallery.co.uk/5-x-coin-capsules-with-39mm-airtite-rings-294-p.asp

Will post back with the results when I've tried them out.

Cheers, Jared.