A while back I bought a NM-MINT white haired Ben Kenobi in a simple purchase with someone that I have dealt with on many occasions and he even mentioned that one of the Bens was one that was originally made for a true authentic original DT saber. I have tried putting authentic single extension sabers through it both with and without the little extension pieces as well as one of those full length 3 dot kinds that go with Bespin Lukes and all of them will barely go through if it is lined up just right and then forced through. If I were to have bought one like this with a single extension I would have taken it back because it is obvious that it is the wrong size hole for the later models which would lead me to believe it is made for something else like a DT. Can anyone enlighten me about this whole situation?